Chiayo IRX2 Guia de Instalação

SYSTEM INSTALLATION GUIDE v3.0www.cie-group.com/soundfieldAugust 2013

Sound Panel ‘AMP’ Connection Details: (refer to Diagram 3 on page 11)• Line In:Balanced line level input terminals for connection of up to ve remot

Diagram 3 - Sound Panel ‘AMP’ Connection Details11Line LevelMic LevelLow HighTONEPOWERGndGndGndrkpS txEtuO giS eniLrwP rvcR v51nI rvcR ciMtuO CD v81nI

12IRX2 Wallmounting Soundfield SystemWarning No connections should be made to the unit whilst the mains power is connectedThe IRX2s unit is a wal

Diagram 413Important Note Do not mix Loudspeaker Impedances between each amplier channel as this can provide an unstable loading to the amplier and

Packs A, B, C, F & G:Before testing the system, ensure that all the batteries required for the transmitters are fully charged.After c

IWM-402 Pendant Transmitter:Remove the rear battery cover from the unit and insert a fully charged battery, ensuring the correct polarity, if you don’

Checking the infrared coverage:When the transmitters and detectors used on the installation have been set, check the infrared coverage in the teaching

Product compliance: These products comply with the following European directives: • EMC directive 89/336/EC (plus amendments) • Low voltage

18‘SoundField’ or a ‘SoundField Voice Reinforcement System’ is essentially the integration of a ‘mini-PA system’ in the classroom.Under quiet classroo

i-ceilings Soundeld Systems provide a complete solution designed for use in teaching and training environments. They utilise the late

i-ceilings Soundeld Packs are supplied with the loudspeakers and infrared equipment in separate boxes. Before going to site please check you have

• IS-20A Standard Infrared Sensor (For use with Soundfield Packs A, B, C, F & G)• IS-30A Optional Ceiling Mounted IR Sensor (For use

This manual is intended for use by installation engineers. The separate user manual should be left with the user. Infrared Wireless Microphone Technol

For use with Pack A, B, C only:A maximum of 5 Outreach Plates can be used with the i-ceilings amplied Sound Panel. The APA/APL (supplied with t

Sound Panel Loudspeaker positioning and installation (Packs A, C & G): In systems using only one i-ceilings Sound Panel, the speaker unit should i

Conventional Wall Speaker Positioning8Concealed Ceiling Soundfield SystemWhen an Armstrong Sound Panel is used, the amplier is an integral part. It s

Introduction:‘AMP’ versions of i-ceilings Sound Panels feature a 20W power amplier pre-installed on the Sound Panel. Sound Panels can be suppli